 |
| HOME PAGE |
| ADVANTAGES |
| HOW IT WORKS |
| TESTING 4 WAY |
| TESTING 2 WAY |
| HOW TO ORDER |
| CONTACT US |
 |
Buzz Machine Co. (office) 6165 Clarkston Rd. Clarkston, MI. 48346 Ph: (1-248) 625-4886 Fax: (1-248) 625-9554 rlsimonson@mindspring.com |
 |
 |
 |
| • Retail ( .pdf ) Flier |
| • Wholesale ( .pdf ) Flier |
| ------ The Spirit Net ------ - Ham Radio Bible Study - " Live " audio streaming 9:00 PM to 10:30 PM EST. - Saturday thru Thursday - |
| Buzzbar A Adapter ( .pdf ) Flier |
 |
| Buzzbar G Adapter ( .pdf ) Flier |
 |
THE DETAILS
The BUZZBAR 2-Way and 4-Way pallet pullers are essentially made up of three details.
1. The Cradle.
2. The Handle.
3. And the ( 9mm ) Quick Link.
The Cradle is connected to the end of the Handle by ( 3 ) 5/16-18 Flat Head Soc. Screws. On the other end of the Handle, the ( 9mm ) Quick Link is connected.
TO CONNECT THE PULLER TO THE PALLET
1. Place the cradle end of the puller behind the lower deck board of the stringer pallet.
2. Slide the cradle sideways under the stringer board and pull back. That's all there is to it. You are now locked into position.
Above is a side view of the puller in locked position.
Below is a view from the inside of a 2-way stringer pallet being pulled by a BUZZBAR 2-Way pallet puller.
HOW IT WORKS
When in this locked position, the cradle pulls on the lower deck board edge ( perpendicular to the grain of the deck board ) to move the entire pallet along. At the same time the cradle finger and the handle steers the pallet in the direction of the pull.
BUZZBAR® pallet pullers are to be used with proof coil chain and not to be used for lifting.
Russell L. Simonson - Inventor - Manufacturer/Engineer
BUZZBAR® is a Registered Trademark of Buzz Machine Co. (Est.1977) Clarkston, MI. USA.